this is what she looked like when I purchased her and put her in my collection
decided to put the false floor where Sam is pointing, keep the center of gravity as low as possible.
measured, remeasured and measured some more, marked where the floor would end up.
black pipe is for rod tubes that will be embedded in both sides of boat. Blue conduit is for electrical
even though this will be my Elk River boat, she is getting eyeballs, never know when I might have her out on the lake and it could get dark, plus I'm doing this boat up the way I think a Elk boat should be. Don't cost much more to get it right.
got brave
took the saw and went postal, and removed these, they were just in the way
now to get down to business
got the part done I had been dreading, my lungs and dust don't mix, but this suit was worth it's weight in gold, and the full face I borrowed from one of my work buds.
Now I can make the false floor panels and get started putting them in.
09/23/10
Why on earth do people cut holes in the bottom of perfectly good boat bottoms? I filled the one in the bottom and rear that was used for Livewell.
Be forewarned, I will retain BD if anyone tries to use this jig
Foam backing on bottom, fiberglass hull pieces from light cut out as rigid backing, pressure against bottom with a 2 x 4 and couple pry bars. Max is sitting in background protecting me
10/07/10
put the raceways in for the electrical tonight, got them glassed in, not only with they carry the wires but are put in so that the floor with rest on them for extra support, now onto the floor panels and the side gussets
10/17/10
got the side gussets glassed in
10/21/10
got the first panel out of the form, it's 2 layers of 18oz woven roving, 2nd and 3rd will be one layer, install and build up in boat.
11/22/10
got the Anchor Rein gusset glassed in and Anchor Rein mounted, front trolling plug also in place
used fiberglass from the seats I cut out to make these tabs, they are for rear support of the seat/casting deck
12/01/10
with the colder weather had to come inside and work, bulkhead for the front of the seat/casting platform and 4 pieces for the battery box/seat
12/02/10
got the box squared up and taped on the outside, two layers of 6oz and epoxy on the corners
12/10/10
putting the fillet's in the corners, probably over doing it, rather have to much than not enough
09/17/12
work and cold weather has put this project on the back burner, finally for a few days off in a roll, but worked 21 straight before I got these off
got back serious on the boat, wanted to get the major glass work done before cooler weather
solid cover of woven roving front to rear
wetting it down as I go from back to front
all glassed down
bulkhead, will be storage behind it, full length cover will be seat/casting deck
rod tubes
11/25/12
rear casting deck
making a tube to cut in half for rod grip holders, wax paper over PVC tube for the form
mounting one in place
01/14/13
installed the rear trolling plug mount
installed the bulkhead side extensions
10/31/13
01/14/14
primer
top coat
05/15/14